settings
162 Citan 12001-C/15001-C BAH0094-3 12.2019
15. Install the foam insert (Fig. 213/1) and
sealing ring (Fig. 213/2).
16. Install the inner distributor cover (Fig.
213/3).
17. Install the ring (Fig. 213/4).
18. Install the outer distributor cover (Fig.
213/5).
19. Check the function of the tramline control.
Fig. 213
8.17 Half-sided switching off
To actuate the electric one-sided switching, observe the "ISOBUS
software" operating manual.
Do not forget to switch the half-width of the implement back on again
after turning at the end of the field.
1. Unfold the implement sections (see section
"Unfolding/folding the implement booms",
page 173).
2. Disengage the tractor PTO shaft, apply the
tractor parking brake, switch off the tractor
engine, and remove the ignition key.
Fig. 214
DANGER
Switch off the tractor PTO shaft,
apply the tractor parking brake,
switch off the tractor engine and
remove the ignition key.
3. Throw the lever to the right (Fig. 214/1) and
lock it:
ï‚· the right side of the implement is switched
off.
ï‚· requires the halving of the application rate.