Amazone Citan 12001-C User Manual

Cleaning, maintenance and repairs
218 Citan 12001-C/15001-C BAH0094-3 12.2019
12.11 Cleaning the oil cooling / air pre-warming
1. Position the implement on a horizontal
surface.
2. Clean the fan suction protective screen
(Fig. 313/3).
3. Loosen and remove all of the knurled nuts
(Fig. 313/1).
4. Remove the fan suction protective screen.
5. Clean the heat exchanger (Fig. 313/2).
6. Install the screen basket.
7. Put on all of the knurled nuts and tighten by
hand.
Fig. 313
12.12 Wheels / tyres
Adhere to the inspection intervals
(see section Maintenance schedule – overview, page 211).
12.12.1 Check the inflation pressure of the running gear tyres
Inflate the tyres with the indicated nominal pressure.
 The value for the nominal pressure can be read on the rim.
 The value for the nominal pressure can be obtained from the tyre
manufacturer.
 Check the tyre pressure regularly when the tyres are cold, i.e.
before starting to drive, see page 49.
 The difference in pressure between the tyres on one axle must
be no greater than 0.1 bar.
 Tyre pressure can be raised by up to 1 bar after a fast run or in
warm weather. Tyre pressure should never be reduced in this
case, as it is then too low when the tyres cool down.

Amazone Citan 12001-C Specifications

General

Brand	Amazone
Model	Citan 12001-C
Category	Farm Equipment
Language	English