Ambiente LUNA STAT - Setting Program Mode Selection

8
PROGRAMMABLE MODE
(
5+2 AND 7 DAY
)
SETTING YOUR PROGRAM MODE SELECTION
This Luna Stat has been set by default to a Programmable
thermostat in 5+2 day programming (Weekdays + Weekend).
To change between programmable, non-programmable and set
back thermostat follow these steps.
1. Press MENU till the ‘SET SETUP’ main menu item flashes.
2. Press OK 5 times, or until the small digits show ‘05’.
3. Press
to change the large number for the following modes
• 00 – Non Programmable/Set back thermostat
• 01 = Weekday/Weekend programmable
• 02 = 7 day programmable
4. Press OK 10 times, or until the small digit shows ‘15’.
5. Press
to change the large number for the following modes
• 00 – Setback thermostat disabled
• 01 = Setback thermostat enabled (non-programmable only)
6. Press MENU to save the setting and the
button to return to
the home screen.