13
*Note: Exam heating mode will only appear if selected in the engineers functions.
3.7 Setting the Day and Night Temps
Press the SETTING button till
SET TEMP? appears in the display.
Press the OK button to change this user
mode.
Value to alter/confirm will start flashing.
+ or - then OK
DAY TEMP 60 . 0
O
F
Menu End
OK =yes SET =REDO
OK =yes SET =next
SET TEMPS?
+ or - then OK
EXAM TEMP 66 . 0
O
F
+ or - then OK
NITE TEMP 41 . 0
O
F
OK =yes SET =next
SET SYSTEM OFF?
+ or - then OK
DAY TEMP 66 . 0
O
F
Th 09 : 30
AUTO ON
follow ‘SYSTEM OFF’ menu
repeat above procedure
Use the + button to increase the value.
Use the - button to decrease the value.
Press the OK button to accept the value
and advance to the next display.
Press the UNDO button to cancel setting
but save any previous changes.
*
If the control is used
on a system installed
in a sports hall, a temporary
increase in temperature can
be set to improve comfort for
people sitting in the building.
Heating will be controlled to
“temperature 2”.
Exam Heating mode can
only be set during an ON
period and will last only until
the next OFF period unless
cancelled by the UNDO
button.
press or
press or
To Next Page
Loading...
