To Next Page

To Previous Page

6.2.4 The screen image is off-center or there are odd colors.

Try adjusting the brightness, sharpness, contrast, and color balance controls of your

monitor.

Try adjusting the centering and positioning controls of your monitor to position the

picture on the screen.

Set the monitor's RGB inputs (and sync switches, if this option is available) to 75 Ohms,

with the sync set to external.

DFP monitor users: Make sure that the DVI plug of your monitor data cable is digital-

only (DVI-D), not integrated analog/digital (DVI-I). Refer to your monitor's

documentation and contact your supplier or the manufacturer of the DFP monitor for

information on how to obtain a suitable data cable plug.

If you need to use DisplayPort or Mini DisplayPort adapters other than the ones

included with your graphics card, make sure that you use AMD Eyefinity validated

dongles. For more information, see http://support.amd.com/us/eyefinity/Pages/

eyefinity-dongles.aspx.

6.2.5 The operating system warns that the graphics card isn't properly

configured.

Make sure that the display resolution and refresh rate settings you have selected are

supported by the monitor you have connected.

Check the driver installation and make sure that all software is correctly loaded

corresponding to your operating system and applications.

Reinstall the drivers for your graphics card.

6.2.6 There are bus address or interrupt conflicts.

Make sure that the I/O and memory addresses reserved for the graphics board are

not used by other hardware devices. The integrated on-board VGA controller of your

AMD FirePro card uses the following addresses (hex):

•

I/O Address: Standard VGA I/O: 3B0-3DF

•

Memory Addresses: Video RAM: A000-BFFF, Video ROM: C000-C7FF

You cannot change the addresses of your AMD FirePro card. In case of an address

conflict, try to modify the I/O address of the add-on card that causes the conflict.

To support the special graphics processor on the AMD FirePro card, the system BIOS

should automatically assign a system interrupt to the slot where the card is installed.

However, there may be problems if your graphics card does not receive an interrupt

or a system interrupt is used for more than one device. In case of problems, check the

system configuration utility of your operating system for the interrupt assignments.

28 Reference

Questions and Answers:

Need help?

Do you have a question about the AMD FirePro W7000 and is the answer not in the manual?

AMD FirePro W7000 Specifications

General