Ametek BrookField TC Series - Page 50

50 pages

To Previous Page

110-512 BEL/EN

Manufactured by:

PolyScience

6600 W. Touhy Avenue Niles, IL 60714 U.S.A.

1-800-229-7569 ● 1-847-647-0611

www.polyscience.com

Main Page

Table of Contents2
Introduction4
Brookfield Circulating Baths with Standard Digital Temperature Controller4
Performance Specifications5
Heating and Cooling Curves6
General Safety Information8
Safety Recommendations9
Regulatory Compliance and Testing10
Unpacking Your Circulator10
Contents11
Controls and Components12
Quick-Start15
Installation and Startup17
General Site Requirements17
Adding Liquid to the Bath Reservoir17
Pump Inlet and Outlet Connections18
External Closed Loop Circulation18
Refrigeration Control Connections (Refrigerating/Heating Circulators Only)19
Electrical Power19
RS232 Serial Communication20
Controller Setup21
Power21
Safety Set Temperature22
Normal Operation23
Keys and Controls23
Turning Your Circulator on23
Main Operational Display (Home)24
Set-Up Sub-Menus24
Adjusting the Temperature Set Point25
Selecting the Temperature Unit26
Selecting the Pump Speed27
Calibrating Your Circulator28
Setting the Low Limit Temperature29
Setting the High Limit Temperature30
Selecting the Serial Communication Baud Rate31
Setting the Auto Cool Temperature32
Resetting the Factory Default Values32
Changing Your Circulator's Viewing Angle33
Loss of Power Restart33
Inert Gas Purge33
Display Messages and Alarms34
Routine Maintenance and Troubleshooting35
Maintaining Clear Bath Water35
Draining the Bath Reservoir35
Checking the Over-Temperature Safety System36
Cleaning Your Circulator37
Temperature Controller37
Bath Reservoir37
Pump Impeller37
Condenser, Air Vents, and Reusable Filter (Refrigerating / Heating Circulators Only)37
Temperature Controller Removal and Re-Installation38
Removal38
Re-Installation39
Troubleshooting Chart40
Technical Information42
Reservoir Fluids42
Application Notes43
RS232 Communications43
Using Bath Controller with Compatible Brookfield Engineering Software44
Using Bath Controller with the DV-III+, DV-III Ultra or DV3T Rheometer in Standalone Mode44
RS232 - for Use Without Brookfield Software (for Customers Using Their Own Software)45
Equipment Disposal (WEEE Directive)47
Replacement Parts, Optional Accessories & Fluids48
Warranty Repair and Service49

Ametek BrookField TC Series - Page 50

Table of Contents

Related product manuals