Ametek JOFRA CTC-140 A Service Manual

4 26-03-2004 123200 03
1.0 General
1.1 Introduction
This service manual applies to the following instruments:
• Jofra CTC-140 A
(with or without RS232)
• Jofra CTC-320 A
(with or without RS232)
• Jofra CTC-320 B
(with or without RS232)
• Jofra CTC-650 A
(with or without RS232)
• Jofra CTC-650 B
(with or without RS232)
• Jofra CTC-1200 A
(with RS232)
• JF Instruments MTC-140 A
(without RS232)
• JF Instruments MTC-320 A
(without RS232)
• JF Instruments MTC-650 A
(without RS232)
All calibrators are produced from quality components by skilled staff.
Each calibrator passes several tests during assembly and undergoes
a final inspection and test following a special calibration procedure
laid down by our technical staff.
Caution…
If you decide to check and/or re-calibrate the calibrator, you
must always use certified test equipment only and ensure
proper contact between the test probe and the well of the
calibrator.
Operating guidelines and technical specifications are outlined in the
reference manual order no. 123198 for CTC instruments and in the
user manual order no. 105337 for MTC instruments. Please note that
these are only available in English.

Ametek JOFRA CTC-140 A Specifications

General

Brand	Ametek
Model	JOFRA CTC-140 A
Category	Measuring Instruments
Language	English