Ametek NetWave 20 User Manual

AMETEK CTs NetWave
7.2.7. General technical data for all 3-phase NetWave
Regulation
Voltage sense
internal or external, 4 wires
Sense range
Uset ≥ 100 V ac or dc: ± 5% of line setting
Distortion (THD)
Less than 0.5% (for 50 Hz / 60 Hz)
Output voltage Stability
Better than 0.1%
Output voltage Accuracy
DC: ± 0.2 % of set value ± 0.15 % of full scale,
AC: add ± 0.1 % of set frequency / 1000
Output Noise
<50V: 110 mVrms; ≥50 V < 320 mVrms +0.02% of set value
Max. compen. drop on wires
5% of max. nominal voltage
Current limiter accuracy
<5%
Current limiter steps
1 A
Current limiter range
See chapter 0
Current Limiter Ranges
Current limiter in
parallel switching
Minimum current : 10 A
Current Range: Multiply this value by three when using
Parallel Switching on 3 Phases models
Protection
Over current
Over temperature
Over voltage mains supply
Low voltage mains supply
Slew Rate
8 V / µs
Phase
Resolution 1°
Waveform generator
Segment types DC
DC, Ramp, Square, Triangle, Sawtooth, Step, Sine, Sine sweep,
Sine ramp, Damped sinewave, Sine ripple, Profile, Square sweep, Noise,
Sine Dwell, Sinc, Harmonic, Exponent ...
Segment types AC
Sine ( flat curve, flat RMS adapted), Modulation, Sine sweep,
Sweep on Sine, Sine up/down, Sine unbalance, Sine Offset, Sine
Switching, Over Swing, Harmonic, Interharmonic, Interharmonic step,
Harmonic distortion ...
Segments with option Aircraft
Sine offset ( dc offset to sine ), Sine Dip, Sine Exponent
Segment duration
Unlimited
Data file import
CSV or Excel
Measurements (option)
Input channels
6 channels (Opt-3 NWB required)
Input voltage ranges
25 V, 50 V, 100 V, 250 V and 600V (old systems 550 V) ;
unipolar or bipolar
Input current ranges
10 A, 25 A, 50 A, 100 A and 220 A;
unipolar or bipolar
Resolution
16 Bit
Accuracy
Voltage: ± 0.05 % of reading ± 0.2 % of range
Current: ± 0.2 % of reading ± 0.3 % of range
Frequency range
DC – 100 kHz
Sampling rate (selectable)
5 S/s – 500 kS/s
Memory
Min. 40GB on Hard disk
File size max. 1 GByte
Display and Controls
Display
Text LCD 2 lines, 40 characters
LED indicators
Power On
Active output channel
Trigger
Running status
Functional status hard disk
Operation
6 function keys
Test On : ON / OFF key for the power source
Inputs & Outputs
Trigger
2 inputs, 2 outputs

Ametek NetWave 20 Specifications

General

Brand	Ametek
Model	NetWave 20
Category	Industrial Equipment
Language	English