AMETEK CTs NetWave
5.2.7. Source Mode
This menu set the source Mode of each line to one of the following mode:
- Intern,
- Extern (only in DC mode) or
- AMP200.
Source mode cannot be changed when parallel switching is enabled (parallel switching requires all source as
intern defined).
Source Mode: - Intern,
- Extern (only in DC mode) or
- AMP200.
Polarity: Polarity for DC mode
- Unipolar
- Bipolar
Input: Input voltage for external source range [1;10]
Output: Output voltage range [10;999],according to the external
source capacity
Remark: For Intern and AMP200N,
Polarity, Input and Output Voltage are displayed for
information and are not settable.
Remark: This menu is only available for NetWave that have
external connectors for (signal out/source in bridge).
Availability is strongly related to Extern AC/DC operation
mode capability (only in the way that externalized
connectors are present).
5.2.8. Operation Mode
This Menu is only available on the NetWave 7.3, 20.x, 30.x, 60.x, 67.x, 90.x and 108.x. For more Information,
please refer to Annex 9.2.
Setting of the Operation Mode gives you the option to use the NetWave in following Modes:
Standard, Simple AC or Source AC.
Standard: NetWave operates as described in this manual.
Default : Standard
Simple AC: NetWave is remote controlled or can play XML
SimpleWaveFiles (XYZ.ssa) which are stored on the
NetWave. Refer to Annex 9.2.2
Source AC: NetWave is used as a AC Source, where the output is
synchronized to a Reference signal on Trigger IN 2
Refer to Annex 9.2.3
External: NetWave is used as an Amplifier for the Reference signal
applied to BNC External Signal IN
Refer to Annex 9.2.4
To Next Page
Loading...
Need help?
General
