Ametek NetWave 3.1 User Manual

AMETEK CTs NetWave
Measurements (option)
Input channels
2 channels (Opt-1 NWB required)
Input voltage ranges
25 V, 50 V, 100 V, 250 V and 500 V;
unipolar or bipolar
Input current ranges
7 A, 15 A, 30 A, 50 A and 150 A; (set in software)
unipolar or bipolar
Resolution
16 Bit
Accuracy
Voltage better than 0.2% @50/60Hz, of selected range
Current better than 0.5% @50/60Hz, of selected range
Frequency range
DC – 50 kHz
Sampling rate (selectable)
5 S/s – 100 kS/s
Memory
Min. 40 GB on Hard disk
File size max. 1 GByte
Display and Controls
Display
Text LCD 2 lines, 40 characters
LED indicators
Power On
Active output channel
Trigger
Running status
Functional status hard disk
Operation
6 function keys
Test On : ON / OFF key for the power source
Inputs & Outputs
Trigger
2 inputs, 2 outputs
DUT monitoring
2 inputs, configurable
Signal output
Output Signal of internal arbitrary generator
(available only on NetWave 7.3, 30.2 & 60.2)
Source Input
Input for external or internal arbitrary signal generator
(available only on NetWave 7.3)
Control
Computer
PC 104 computer
AMD Microprocessor 500 MHz
256 MB RAM
Operating system
Linux, with Real time extension
DSP Signal processor
Motorola DSP 56303
Interfaces
GPIB Address 1...30
Ethernet
USB (for Measure & Analyze NW-Board option)
USB (for memory stick and ext. hard disc) I max. 500mA
RS232 ( input from DPA analyzer)
Frame bus (internal system bus)
Environmental Hard disk
Temperature
operating
5 – 40°C
storage
-20 – 60°C
gradient
20°C / hour
Humidity
10% – 90% non-condensing
Vibration
Operating
1.0G
Non-Operating
5.0G
Shock
Operating
225G ( 2ms)
Non-Operating
900G ( 1ms)
General Data

Ametek NetWave 3.1 Specifications

General

Brand	Ametek
Model	NetWave 3.1
Category	Industrial Equipment
Language	English