16 Amico Mobility Solutions Corporation
Operating the GoLift
DOWN button
UP button
The Amico GoLift is switched on automatically when a button on the hand control is pressed.
The Amico GoLift switches off automatically after approximately three minutes without activation. To operate the lift,
press and hold the UP or DOWN button on the hand control to raise or lower the strap.
Charging the GoLift
The charger contacts with two metal charging strips located inside the track. Whenever
the lift is over a section of track with charging strips, it will automatically start to charge
the lift if the battery is low.
The batteries should be charged on a regular basis. It is recommended that the lift be left
on charge when not in operation, and at the end of each day. This will maximize the life
cycle of the batteries.
The GoLift may remain connected to the charger indefinitely since the charger has a built-
in regulator, eliminating the danger of overcharging.
As a general rule, it is recommended that the Carry Bar be raised to a height that will not interfere with anything or
anyone while the lift is not in use.
WARNING: Do not drain the batteries excessively. This will dramatically reduce the lifespan of the batteries.
If the battery level is critically low (see LED and Buzzer Functions section), be sure to recharge the battery as
soon as possible.
CAUTION: Charge the lift batteries to full and unplug them before storing. Plug in and recharge the batteries
every three months if the lift is being stored for extended periods of time.
To Next Page
Loading...
