30 Amico Mobility Solutions Corporation
Electro-Magnetic Compliance Data for Amico GoLift
Recommended separation distances between portable and mobile RF communications equipment and the
[EQUIPMENT or SYSTEM]
The [EQUIPMENT or SYSTEM] is intended for use in an electromagnetic environment in which radiated RF disturbances
are control LED. The customer or the user of the [EQUIPMENT or SYSTEM] can help prevent electromagnetic interference
by maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the
[EQUIPMENT or SYSTEM] as recommended below, according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter W
Separation distance according to frequency of transmitter M
150 kHz to 80 MHz
d = 1.2√P
150 kHz to 80 MHz
d = 1.2√P
800 MHz to 2,5 GHz
d = 1.2√P
0,01 0.12 0.12 0.23
0,1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of
the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects and people.
Disposal
• The Amico GoLift doesn’t contain any dangerous goods
• The components of the Amico GoLift should be properly disposed at the end of its shelf-life
• Make sure that the materials are carefully separated
• The electrical conducting boards should be submitted to an appropriate recycling proceeding
• The rest of the components should be disposed according to the contained materials
To Next Page
Loading...
