www.amico.com 17
LED and Buzzer Functions
WAKING UP A LIFT AFTER CHARGING
When waking the lift from the sleep state, there will be a
sequence of three LED statuses before the lift goes back to
sleep. The LED color indications will differ slightly between
waking the lift while charging and while not charging. See the
table below for details.
Red Amber Green
STATUS 1:
Will always show green when the lift wakes up
for four seconds.
STATUS 2:
Will be amber for four seconds to confirm that
it is currently charging.
a. If the light remains green, this means
the lift is on battery power and not
being charged.
STATUS 3:
Shows the current battery level.
a. For a lift on charge, the light will
change from amber to green after four
seconds to indicate lift is at full charge.
Otherwise, the amber light will remain
for three minutes after inactivity before
the lift goes back to sleep.
b. For a lift on battery power, the light
will remain green for one minute if the
battery level is acceptable. If battery
level is low, the LED will change from
green to amber after nine seconds and
blink amber once per second. If battery
level is critical, the LED will change
from green to solid red after nine
seconds, beeping once every three
seconds. These states will remain until
the lift goes back to a sleep state after
one minute of inactivity.
LED INDICATORS
LED Status’ While Lift is Charging
LED Color Duration
Wake
GREEN (at full charge)
4 secs
Charging indicator
AMBER (low battery level)
4 secs
In use/idle
GREEN (at full charge)
3 mins
AMBER (low battery level)
Sleep (if inactive)
Off
LED Status’ While Lift is on Battery Power
LED Color LED Duration Beeping
Wake
GREEN (at full charge)
10 secs None
In use/idle
Continuous solid GREEN
(at full charge)
1 min
None
Blinking AMBER 1x/s
(low battery level)
None
Continuous solid RED
(critical battery level)
1x/3s
Sleep
(if inactive)
Off
n/a n/a
To Next Page
Loading...
