How to fix amber BATT LED flashing on Amico Sentinel Controller?
If the amber BATT LED is flashing on your Amico Sentinel Controller, it could be due to incorrect battery orientation or a low battery. Ensure the batteries are correctly installed according to the battery orientation symbols. If they are correctly oriented, replace the batteries.
Why is the red CHECK LED flashing on my Amico Sentinel Controller?
If the red CHECK LED is flashing on your Amico Sentinel Controller, it could be due to contamination or debris on the sensor window. You can try replacing the disposable body kit, including the sensor window, and then reset and calibrate the system. Alternatively, clean or replace the sensor window itself before resetting and calibrating the system.
General| Brand | Amico |
|---|---|
| Model | Scout Series |
| Category | Controller |
| Language | English |
Defines the structure and options for Scout model numbers, including color coding.
Defines the structure and options for Sentinel model numbers, including color coding.
Explains hazard symbols (Warning, Caution) and their meanings for safe operation.
Details the proper application and cautions against misuse of the vacuum regulator.
Lists technical details like gauge accuracy, ports, modes, and environmental limits.
Step-by-step guide for setting and using continuous vacuum levels.
Instructions for operating the regulator in intermittent cycling mode.
How to achieve and use maximum vacuum settings.
Essential tests to perform before patient use to ensure functionality and safety.
Process for setting vacuum levels and verifying consistency.
Specific pre-use checks for pediatric and neonatal models, including safety valve function.
Procedure to test Sentinel unit's battery power and contamination status.
Detailed guide on adjusting the ON/OFF timing for intermittent mode.
Method for cleaning Scout regulators using Cidex solution via reverse flush.
Procedure for replacing the disposable body of the Scout regulator.
Detailed step-by-step guide for replacing the Scout disposable body.
Method for cleaning Sentinel regulators using Cidex solution via reverse flush.
Procedure for replacing the disposable body of the Sentinel regulator.
Detailed step-by-step guide for replacing the Sentinel disposable body.
Routine maintenance tasks to perform after each patient use.
Steps for safely removing and installing new batteries in the Sentinel unit.
Instruction to calibrate the sensor after battery replacement.
Method to test the Sentinel unit's battery and contamination status.
Detailed steps for calibrating or resetting the Sentinel unit.
Troubleshooting Amber BATT and Red CHECK LED status on Sentinel models.
Addresses issues like no vacuum, incorrect cycling, or knob stiffness.
Covers casing alignment, selector switch problems, and leaks.
Troubleshooting when the TEST button yields no LED indication.
Diagram and list of parts for the Scout vacuum regulator assembly.
Diagram and list of parts for the Sentinel vacuum regulator assembly.
Details the warranty period, exclusions, and limitations of liability.
Outlines the steps and requirements for submitting a warranty claim.
To Next Page