11.6 Miscellaneous Settings
When you enter to “Miscellaneous Settings” menu,
you will see a screen like below:
1 Channel list num: This item provides below
options: 1/2/3, you can press [OK] and [up/
down] key to select each mode circularly.
2 Subtitle Auto: You can press [Left/Right] key
to select “On” or “Off”. If the current
channel has subtitle information, it will be
showed up automatically while this function
is “ON”, if this function is “OFF”, you need
turn on the subtitle manually by press
[SUBTITLE] key.
3 Auto Power Down: You can press
[Left/Right] key to select the time or “Off”, if
you select time, duration this time if no any
operation on receiver, it will go to standby
mode.
4 Standby mods: if set to “Real”, Press power
key receiver will be in real standby status,
the consumption will less than 0.5 Watt. if
it’s set to “Fake” ,Press power key, receiver
will be in fake standby status.
5 OSD Timeout: When you switch channels
in full screen, there will show up some
information about current channel on the
lower of the screen. And regarding to the
duration of these information show up on
the screen, you can press [OK] and [up/
down] key to set the time. The range of the
duration is “1 second ~ 10seconds”.
6 Position: control display position of the info
bar in full screen mode.You can choose
“bottom” or “top”.
7 Debug: You can setting debug On/Off with
this menu.
11.7 Software Upgrade
11.7.1 Upgrade By USB
In this menu you can upgrade the software from
USB conveniently, Press “Left/Right” button
select USB A or USB B; press ' OK ' button to
enter.
In this menu you can select the Upgrade Mode
among Software (No channel list), Channel list,
All SW+bootloader and All SW+Channel list,
and you can select the appropriate upgrade file
on "Upgrade File" item. After you select the
"Upgrade Mode" and "Upgrade File", press ' OK
' button on "Start" item, the receiver can upgrade
automaticlly
Note:
You must put the upgrade file on the /ROOT
DIRECTORY of the USB storage.
11.7.2 Backup to USB
To Next Page
Loading...
