In this menu ,you can dump the software to the
USB equipment
1 In "Backup file", you can press [OK] key to
edit the file name.; Press “Left/Right” button
select USB A or USB B;
2 In "Backup to USB", you can press [OK] to
start backup software .
11.7.3 Upgrade By Terrestrial:
This function can upgrade the software through
signal lines from the Terrestrial
2 Select or input the Frequency, Bandwidth and
download PID, these parameters you can get from
your provider.
3 Then move the highlight to the start button and
press [OK] button to start upgrade.
11.8 Default Setting
11.8.1 Default Value:
When you press [OK] key In the “Default
Setting” item:
1 There will pop a dialogue for you to enter
the password, and the default password is
“0000”.
2 After you input the correct password,
there will show a warning message to
inquiry you “The operation will load default
and erase all the channels that user
added, continue?”.
3 If you select “OK” option, the all revised
parameters of the receiver will reset to
default value. Please carefully to using
this function.
4 In step 1 and step 2, press[Exit]key can
draw back from this item and without
saving.
11.8.2 Delete All Channel:
When you press [OK] key in the “Delete All
Channel” item, it will pop a dialogue ask you
To Next Page
