ADS 70 / ACR 70 D 11
Safety regulations :
3.4 Warning stickers on the vibration rammer :
Safety labels and warning stickers must be kept completely legible and must absolutely be observed.
Damaged and illegible safety labels and warning stickers must immediately be renewed.
All labels and stickers can be ordered according to our spare parts list.
3.5 Loading the vibration rammer :
- The rammer must be secured against tipping over or sliding.
- On transport vehicles, the rammer must be secured so that it cannot roll down, slide or tip over.
There is danger to life for persons who
• step under suspended loads or who stand underneath suspended loads.
3.6 Starting the vibration rammer :
3.6.1 Before start-up :
- The rammer must only be operated from the operator’s stand which is always behind the machine.
- Before start-up, the operator must make himself familiar with the equipment, with operating and control
elements as well as with the functioning of the machine.
- The operator must make use of his personal protective equipment such as safety helmet, safety boots etc.
Before start-up, always check whether :
• there are persons or obstacles beside or underneath the rammer
• the rammer is free of oily or inflammable substances
• all levers are free of grease, oil, fuel, dirt, snow or ice
• the rammer shows any obvious defects
• all safety devices are firmly in their place
• all operating elements work all right
- Do never start the rammer if the control elements are defective.
- Do not attach any loose objects to the machine.
3.6.2 Start-up :
For starting the rammer, all control levers must be placed in „neutral position“.
Check all indicator and control elements after start-up.
To Next Page
Loading...
Need help?
General
