Ammann ADS 70 - Loading and Transport; Operation; Control before Use; Refuelling

ADS 70 / ACR 70 D 15
Operation :
4.0 Loading and transport :
• For loading the rammer with a lifting device,
a cross-strut „Q“ is installed to the middle of
the handle bar „H“ (Fig. 6).
Attention :
• In order to avoid any danger or risk to persons, do only use ramps with a sufficient load capacity
and which are safely secured.
• The rammer must be lashed down for transport so that it is secured against sliding or tipping over.
• Use appropriate lifting devices.
Note :
- See „Safety regulations“ page 9.
- For weights, see „Technical specifications“ on page 5.
_________________________________________________________________________________
5.0 Operation
5.1 Control before use :
• Avoid any type of work which might seem to be hazardous or which might reduce the stability of
the rammer.
• Control the rammer visually and have any damages of faults repaired.
• Check that there are no leaking points in the fuel system or in the bellow.
5.2 Refuelling :
• Do only use pure diesel fuel.
• Close the fuel tank immediately after having filled it and pay attention to utmost cleanness.
Danger :
Fire risk !
• Do only refuel the rammer with the engine stopped. • Do not breathe in fuel vapours.
• No open fire, do not smoke.
Fig. 6