Ammann ARX 20 - Engine Starting and Driving Controls

60 ARX 1
1201281 A | 24.07.2013
7.4 Start the engine
7.4.1 Ignition switch
7.4.2 Start the engine
1 Fold the vandalism protection cover all the way back.
2 Move the operating lever into the neutral position until it locks in.
3 Put the speed adjusting lever into the idle position.
4 Turn the ignition key clockwise to position III.
5* Release the ignition key as soon as the engine starts.
Fig. 7-5 Starting motor / position of operating lever and speed adjusting lever
NOTE The control lamps for engine oil pressure, charging, hydraulic brake
release/supply pressure light up when the ignition is switched on. They
extinguish once the engine is running.
Pre-heating If the outside temperature is below 0°C:
1 Turn the ignition key to position II
1.1 hold it in this position for 15sec.
2 Turn the ignition key further to position III.
NOTE When starting and driving the roller from cold, with cold hydraulic oil, braking
distances are longer than when the oil has reached normal working
temperature.
P PARK
In this position you can switch on the parking light. The remaining electrical
loads are off.
0Off
All electrical loads are off.
I Ignition on
All electrical consumers can be switched on.
II Pre-heating
III Start