EasyManua.ls Logo

Ammann ARX 20 - Battery Cut-off Switch Operation

Ammann ARX 20
166 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Options 79
1201281 A | 24.07.2013
8.13 Brake warning buzzer
The warning buzzer is active as soon as the seat contact is activated. The warning
buzzer sounds until the locking brake catches.
8.14 Battery cut-off switch
The battery cut-off switch interrupts the power supply from the battery to the roller.
Switch off the battery cut-off switch if the roller is not in operation for longer than two
days.
NOTE Always disconnect the power supply when working on the electrical system.
8.14.1 Switching battery cut-off switch on / off
The battery cut-off switch is located at the rear on the battery plate.
Switching on
the power
1 Turn the red key of the battery cut-off switch left to horizontal position.
If fitted, the roller is now supplied by the starter battery.
Fig. 8-10 Switching onthe power
DANGER
Rollover hazard when driving the roller!
Get out of the danger zone immediately!
Personnel may not stand in front of or behind the roller while it
is in operation.
!

Table of Contents

Related product manuals