16
5 FUNCTIONING
5.1 OPERATORS
The machine has been projected to be used by only one operator.
The staff assigned to operate with the machine, must be in possession (or acquire through an
adequate training) the requirements indicated here below, and, in addition, to have the knowledge
of this handbook and of every information concerning safety:
• General and technical culture sufficient to comprehend this handbook contents and understand
properly the drawings and schemes
• Knowledge of sanitary conditions, technological and anti-accidental norms
• Overall knowledge of line and plant where the machine is inserted
• Specific experience frames assembly & working technologies
• To know how operate in case of emergency, where to find the individual protection means and how
to use them properly.
The Maintenance person, in addition to the above mentioned characteristics, must be in possession
of an adequate technical education.
5.2 CONTROL PANEL
F1 - F6 FUNCTION KEYS
MENU GO BACK TO THE PREVIOUS MENU
RESET RE-INITIALIZE THE BOARD
1 - 9 TO INPUT NUMERIC DATA
A - Z TO INPUT ALPHABETICAL DATA
TC V-NAILS COUNTER
T ADJUSTMENT SET
YELLOW KEYS NAVIGATION KEYS
S1 S4 SPEED SHIFTING TYPE 1 IN EXECUTION
(shift) S1 S4 SPEED SHIFTING TYPE 2 IN EXECUTION
S5 FUTURE APPLICATIONS
SPACE INSERTION OF EDITING SPACES
SHIFT ACTIVATION ALPHABETICAL KEYS
DEL EDITING CHARACTER DELETION
ENTER DATA CONFIRMATION OR CHOICE
M- M+ DELETE/INSERT POSITIONS
EXE PROGRAM EXECUTION
STOP STOP THE MOVEMENTS
To Next Page
Loading...