30
9.2.e The electronic part does not work
Possible cause Remedy
Machine disconnected from the electric network or
one or more interrupted fuses t Connect the machine with the electric network
t Unscrew the panel located on the rear side of
the oorstand: verify by using a tester the
fuses continuity and replace it if necessary
1. Network lter board M003/x: delayed 4A fuse
(mod. 5x20 glass)
2. Board M021/x....F1 d elayed 10A fuse (mod . 5x20 glass)
3. F2 delayed 6,3A fuse (mod. 5x20 glass)
Wro n g vo lt a g e t connect the machine to a 120 V socket
If t he above list ed conditions are corre ct and t he failu re still exist s
t call AMP or your local distributor’s Assistance service
9.2.f Wishing to insert several V-nails one upon the other in the same point, they do not
stack properly or tilt during their insertion
Possible cause Remedy
Wro n g V-n a ils t replace the V-nails with the proper ones
Improper clamping, (the frame moves during
th e insertion of V-nails) t verify and ifnecessary adjust the vertical and
fr ontal clamps positions
t increase the pressure by using the regulator
9.3 REQUEST OF ASSISTANCE
For any information regarding Use, Maintenance, Installation, etc.. We remain at your disposal.
The Customer has to formulate clearly the questions. Call or Send us a detailed fax about the
nature of the problems. For eventual explanations we recommend you make reference to this handbook
and to the instruct ions liste d in the parag rap h 1.2.
www.etcher-amp.com
Phone: 1-800-322-4204
FAX: 1-800-426-7019
E-Mail: customerservice@etcher-amp.com
To Next Page
Loading...