If communication between the Otowave 102 and the computer cannot be
established the message “Device not found” is displayed. The following
points should be checked:
Ensure the environment is suitable (see Section 7)
The computer has its IrDA software properly installed and the
interface enabled
If the computer has been in “Hibernate” mode the IrDA
interface is not always re-enabled; try restarting the computer
The IrDA adapter on the computer is compatible with the
Otowave
Turn the Otowave off and on again before trying to send the
data again
If communication is lost while sending the data the message “Link was
unreliable” will be displayed. Press ◄ to cancel sending the data and start
the operation again.
If any other messages are displayed while sending data, turn the Otowave
off and then on again and try re-sending the data. If the problem persists
contact an Amplivox service centre.
9. Data Management
Records stored in the database of the Otowave 102 can be listed, viewed,
deleted, printed or sent to a computer using the DATA MANAGEMENT
option of the main menu:
To Next Page
Loading...
