OM001-16 Otowave 102 Operating Manual Page 29
Transfer records to a computer.
Select:
UNSENT RECORDS – Send all
records not previously sent.
ALL RECORDS – Send all records
Set the internal clock date and time;
use the ◄ & ► keys to select a
field and the ▲ & ▼ keys to adjust
the value.
Select when reflexes will be
measured (see Section 5.5):
ALWAYS MEASURE
NEVER MEASURE
ONLY IF PEAK FOUND
PROMPT TO MEASURE
See Section 5.5. Set to 100dB (with
5dB or 10dB steps) or 95dB, 90dB
or 85dB with 5dB steps.
See Section 5.5. Default 500, 1000,
2000 and 4000 Hz (for 102-4)
See Section 5.5. Default 0.03 ml
See Section 5.5. Default YES
See Section 5.5. Default 2 Hz
Select Able AP1300 or Martel
MCP8830 (also use Martel for
Sanibel MPT-II)
Select Alkaline or NiMH (This
effects the battery state display and
low battery warning).
The time after which the unit turns
off automatically if no key is
pressed. Select 90 or 180 seconds
Change the display contrast. 0 – 15.
Default 7.
Select QUICK or THOROUGH
See Section 5.4.
To Next Page
Loading...
Need help?
General
