244
Hardware Reference Manual – Enova DGX 100 Series Digital Media Switchers
Appendix C – DGX_SHELL Commands
5. Click OK.
The Terminal window opens.
NOTE: If the terminal is open while the Switcher is booting, the terminal window displays status for firmware, hardware, and Ethernet
ports. If the terminal is opened after the switcher has completed the boot process, the terminal window is blank. In either case, press
ENTER to display the DGX_SHELL prompt and begin entering DGX_SHELL commands.
6. At the prompt (DGX_SHELL>), type the command and press the Enter key.
To switch between DGX_SHELL and BCS interfaces:
1. From the DGX_SHELL prompt, type “bcs” followed by <enter> and enter the BCS interface.
2. Enter BCS command(s). (For information on BCS commands, see the Basic Control Structure Protocol Programming Guide at
www.amx.com.)
3. Press CTRL+C to exit the BCS interface and return to the DGX_SHELL interface.
NOTE: In order to be able to send a Control Character (i.e., CTRL+C), Control Characters must be enabled for your Terminal (see
instructions on page 180).
DGX_SHELL>
To Next Page
Loading...
Need help?
General
