2 Load Filament
Load filament automatically:
1. A roll of PLA filament: Filament specifications: Diameter :1.75mm; Material: PLA ;Printing temperature: 200-230℃;
2.Please press rotary button →“ Prepare”→“ Change filament”, the main interface will display “Heating nozzle Please wait……”,the
interface will display “Wait for start of the filament change” after the nozzle temperature rises to the target temperature →
“Wait for filament unload ” →“Insert filament and press button to continue…” → then please press rotary button;
3. Straighten up the filament (or cut the filament into bevels with plier),then pass the filament through the extruder;
4.Meanwhile the main interface will display “Wait for filament load” →“Wait for filament extrude”,please click “Resume print”
to start printing;
5. If the nozzle has filament outflow, the installation of filament is successful. If the installation of filament is not successful,
please select“Extrude more”to re-load.
Attention: The function of automatic material advance and retreat is carried out according to the steps of material return first and material feed later, when the
first printing has not started installing filament yet, please wait for 1 - 3 minutes. After the interface displays “Insert filament and press button to continue”,
insert filament into the extruder for automatic feeding.
To Next Page
Loading...
