ANFIM Pratica - Safety; Intended use; Safety information

11
Praca | EN
Safety
Intended use
The grinder is suitable only for grinding whole roasted espresso beans. Do
not use the grinder to grind other products or objects. It is intended for com-
mercial use and may only be serviced by trained personnel. It may, however,
be operated by other persons in a place where its use is supervised.
Any other use is not considered to comply with intended use and can result
in material damage or even personal injury. Do not make any changes to the
grinder. Neither the manufacturer nor the supplier can accept liability for any
injury or damage resulng from failure to comply with the safety informaon.
Safety informaon
WARNING!
Risk of electric shock!
Improper use, incorrect electrical installaon or a voltage that is too
high can all lead to electric shock.
– Connect the grinder only if the mains voltage of the socket com-
plies with the informaon indicated on the type plate.
– Only connect the grinder to a socket with good accessibility so
that you can disconnect it quickly from the power supply in the
event of a malfuncon.
– Do not use the grinder if you noce any visible damage or if the
power cable or plug is faulty.
– If the grinder power cable is damaged, it must be replaced by
the manufacturer or by qualied personnel in order to avoid
hazards.
– Connect the grinder only to a power supply with a 16 A-slow
fuse. If the power connecon at the installaon locaon of the
grinder is not protected in this way, have a 16 A-slow fuse ed
by a qualied electrician.
– Install the grinder only in locaons where its use can be super-
vised by trained personnel.