ANFIM Pratica - Operation; Thermal protection and restart

17
Praca | EN
Operaon
NOTE!
Risk of overheang!
Exceeding the maximum permissible operang cycle can cause the
grinder to overheat.
– Do not exceed the maximum operang cycle
(see “Technical data” secon).
– Observe the recommended break when the maximum permissi-
ble operang cycle is reached (see “Technical data” secon).
• The grinder has a thermal overcurrent circuit-breaker which
interrupts the electric circuit of the grinder in case of electri-
cal overload.
To use the grinder again, rst set the On/O switch (5) to
switch posion 0 (o).
Then push the release buon (6) in.
You can now switch the grinder on by seng the On/O
switch to switch posion I and resume using the grinder (see
“Troubleshoong” secon).
• The grinder also has a motor protector, which switches o
the grinder when the motor becomes too hot.
As soon as the motor has cooled down, the grinder can be
put into operaon again (see “Troubleshoong” secon).
NOTE!
Risk of damage!
The operator cannot adjust the thermal overcurrent circuit-breaker. If
the circuit-breaker has been triggered several mes, a service partner
must be contacted for advice as the motor winding may be damaged.