20
SINGLE ESPRESSO GRINDER
Grinding espresso beans – Grinding according to a recipe
1. Turn the controller (3) to select the recipe required (see “Selecng
recipe/grinding me” secon).
2. Insert the portalter between the portalter intake (12) and the portal-
ter support (10) unl it touches the start buon (11).
The grinder starts the grinding process automacally, runs for the set
grinding me and then stops. During the grinding process, the remaining
grinding me is counted down on the display (14).
3. Remove the portalter from the portalter intake once the grinding pro-
cess is complete.
Grinding espresso beans – Manual grinding
1. Insert the portalter between the portalter intake (12) and the portal-
ter support (10) unl it touches the start buon (11).
The grinder starts the grinding process automacally when the start but-
ton is triggered. During the grinding process, the symbol appears on the
display and the current grinding me is shown.
2. Remove the portalter from the portalter intake when you want to end
the grinding process.
Suspending grinding (break funcon)
The break funcon automacally suspends grinding when you remove the
portalter from the portalter intake (12) and connues grinding when you
insert the portalter into the portalter intake again and trigger the start
buon (11).
1. Remove the portalter from the portalter intake during grinding to in-
terrupt grinding and stop the grinding me. The symbol for the selected
recipe ashes.
2. Reinsert the portalter between the portalter intake and the portalter
support (10) before the set abort me elapses.
The suspended grinding process is connued automacally unl the
grinding me has elapsed.
• If you do not want to connue with the grinding process,
press and release the controller (3) 1×.
The display jumps directly to the selected mode and the pre-
viously suspended me is deleted.
• The length of the abort me can be set on the menu.
To Next Page
Loading...
