ANFIM Pratica - Cleaning the casing; Cleaning the outlet system

25
Praca | EN
Cleaning the surface on which the grinder stands
1. Switch o the grinder (On/O switch (5) to posion 0) and remove the
power plug from the socket.
2. Li the grinder by the casing with both hands and place on a clean sur-
face.
3. Clean the surface and the underside of the grinder with a damp cloth
and dry the surfaces.
The surfaces must be dry and free from oil and grease.
4. Place the grinder back onto the clean surface.
Cleaning the casing
1. Switch o the grinder (On/O switch (5) to posion 0) and remove the
power plug from the socket.
2. Also clean the following parts of the grinder with a brush:
• the outlet (13),
• the portalter intake (12),
• the start buon (11),
• the portalter support (10),
• the screws (8) for adjusng the portalter support (le and right).
3. Pull the drip tray (9) forward and out of the grinder.
Wipe the casing and the drip tray with a damp cloth as necessary, but at
least once a week.
Cleaning the outlet system
The manufacturer recommends using a brush with nylon bristles
to clean the outlet system.
1. Pull the outlet (13) down and out of the lock (see Fig. I).
2. Clean the outlet on the casing (outlet lock) with a brush.
3. Clean the outlet with a damp cloth and then dry it.
Ensure that you do not damage the outlet.
Fine scratches can have a negave eect on the grinding results,
as espresso grounds adhere to the scratches, which can cause
uctuaons in dispensing.