ANFIM Pratica - Selecting the recipe;grinding time; Setting or changing the recipe;grinding time

19
Praca | EN
• Reduce the grinding degree only while the grinder
is in operaon.
• In order to avoid/eliminate imbalances in seng the grinding
degree, it is advisable rst to set a coarser grinding degree
(about one level/unit above the grinding degree required)
and only then move the grinding degree slide down from
there to the ner grinding degree required.
3. Fix the grinding degree seng as necessary by turning the grinding degree
lock clockwise to the posion (closed) (see Fig. F).
Selecng the recipe/grinding me
– Rotate the controller (3) to select the recipe/grinding type required
(see Fig. H).
The display (14) shows the symbol for the selected recipe, the corres-
ponding grinding me and the recipe number highlighted in white.
Seng or changing the recipe/grinding me
Proceed as follows if you want to set up the grinding me for a new recipe or
change the grinding me of an exisng recipe:
1. Turn the controller (3) to select the recipe required (see “Selecng reci-
pe/grinding me” secon).
2. Press and hold the controller (see Fig. H).
The grinding me set ashes.
3. Rotate the controller to set the grinding me required.
4. Conrm the grinding me set by pressing and releasing the controller 1×.
If you do not adjust any sengs for longer than 5 seconds (by
rotang/pressing the controller), the seng/change to the
grinding me will be cancelled.