4200T CNC Programming and Operations Manual
P/N 70000412F - Sample Programs
19-14 All rights reserved. Subject to change without notice.
31-July-05
Sample Program #7
One operation is required to complete this component. Part must be
extended a minimum of 4.50 inches from chuck jaws with stock size 4.50
inches diameter.
Refer to Figure 19-7. The program below shows a typical format to face,
turn and OD thread a component. A Sub-Program is shown for the Area
Clear Cycle (G73). The Sub-Program describes the Finish Profile of the
component.
4.5"
4.05"
4.00"
0.05" x 45 De
. Chamfer
0.10" x 45 Deg. Chamfer
TOOLS REQUIRED
OPERATION No.1
TOOL No.2
O.D. THREAD
TOOL No.1
ROUGH TURN
3.00" x 10
3.50"
Figure 19-7, Layout for Sample Program #7
To Next Page
Loading...
