Anilam 4200T - Section 4 - G-Codes; Linear and Circular Interpolation; Feedrate and Speed Control

4200T CNC Programming and Operations Manual
P/N 70000412F - Contents
vi All rights reserved. Subject to change without notice.
31-July-05
Manual Mode Settings .....................................................................................................................3-7
Activating Manual Mode Rapid or Feed........................................................................................3-8
Adjusting the Feedrate..................................................................................................................3-8
Adjusting Rapid Move Speed........................................................................................................3-9
Setting Absolute Zero .................................................................................................................3-10
Part Zero.....................................................................................................................................3-10
Jog Moves......................................................................................................................................3-11
Changing the Jog Mode..............................................................................................................3-11
Selecting an Axis ........................................................................................................................3-11
Jogging the Machine (in Increments)..........................................................................................3-12
Jogging the Machine (Continuous Moves)..................................................................................3-12
Manual Data Input (MDI) Mode ......................................................................................................3-12
Using Manual Data Input Mode ..................................................................................................3-13
Handwheel Operation ....................................................................................................................3-13
Operating a Handwheel Mounted on the Manual Panel ............................................................. 3-13
Operating Handwheels Mounted on the Machine .......................................................................3-14
Section 4 - Preparatory Functions: G-Codes
Preparatory Functions: G-Codes......................................................................................................4-1
Rapid Traverse (G0) .....................................................................................................................4-3
Linear Interpolation (G1)...............................................................................................................4-4
Angular Motion Programming Example ........................................................................................4-5
Circular Interpolation (G2 and G3)...............................................................................................4-6
Partial Arcs ...................................................................................................................................4-8
Dwell (G4).....................................................................................................................................4-8
Ellipse (G5)...................................................................................................................................4-9
Non-modal Exact Stop Check (G9)............................................................................................. 4-10
Setting Software Limits (G22).....................................................................................................4-11
Maximum Spindle Speed (G24).................................................................................................. 4-12
Probe Move (G31) ......................................................................................................................4-13
Thread Cutting (G33)..................................................................................................................4-13
Offsets (Work Coordinate System Select) (G53) ........................................................................4-14
Modal Corner Rounding/Chamfering (G59) ................................................................................4-16
Cancel Modal Corner Rounding (G60) .......................................................................................4-18
In-Position Mode (Exact Stop Check) (G61)...............................................................................4-18
Contouring Mode (Cutting Mode) (G64) .....................................................................................4-19
Using Macros (G65, G66, G67) .................................................................................................4-20
Inch Mode (G70) or MM Mode (G71)..........................................................................................4-22
Absolute Mode (G90) or Incremental Mode (G91)......................................................................4-22
Presetting the Axes (G92)...........................................................................................................4-24
Cutting Feedrates in Feed per Minute (G94) ..............................................................................4-25
Cutting Feedrates in Feed Per Revolution (G95)........................................................................4-25
Setting Spindle Speed to Constant Surface Speed (G96) ..........................................................4-26
Setting Spindle Speed to Constant Revolutions Per Minute Speed (G97)..................................4-26
Section 5 - Canned Cycles
Programming a Z-Axis Turning/Boring Cycle with a Defined Profile (G73) ......................................5-1
Programming an X-Axis Facing/Boring Cycle with Defined Profile (G74) ........................................5-4
Programming a Z-Axis Rough Turning or Boring Cycle (G76) .........................................................5-7
Programming an X-Axis Radial (Facing) Roughing Cycle (G77)......................................................5-9