CNC Setup Utility Manual
P/N 70000490C - Other Setup Options
All rights reserved. Subject to change without notice.
10-December-04
3-4
Software Updates
To install an updated version of the CNC software:
1. Insert the disk containing the updated version of the CNC software
into the floppy drive.
2. See Map 1
, Menu E. Highlight Software Update. Press ENTER.
Follow the prompts on the screen to complete the installation. The
installation process takes less than five minutes. If the system cannot
install the new version, it displays an
Error message. Otherwise, the
system displays messages when it has completed each stage of the
installation procedure (Extracting Control Software, and so forth)
3. Answer the prompts to complete the installation.
The system displays a message when the installation is complete and
then restarts automatically.
NOTE: Make a copy of the configuration file prior to any software
update. Refer to āSection 4 - Configuration Utilitiesā for how to
backup and restore a configuration file.
Security
The Security screen allows you to change passwords. For default
passwords, refer to Table 1-4, Default Machine Passwords
.
CAUTION: ANILAM urges you to take particular caution if you change the
passwords that control access to the Setup Utility. If the password is
lost, the operator must erase the current configuration file and
reinstall the software (thus restoring the default password) or restore
the configuration file from a previous back-up. Make a printed copy
before erasing the configuration file. Settings must be input manually
after software installation.
To change the password:
1. See Map 1
, Menu E. Highlight the level of the password to be
changed. Press
ENTER.
The CNC prompts for the old password.
2. Type the old password, and press
ENTER.
The CNC prompts for the new password.
3. Type the new password, and press
ENTER.
The CNC prompts for confirmation of the new password.
4. Re-type the new password, and press
ENTER.
The CNC activates the new password.
To Next Page
