Anilam 3000M - User Manual

www.anilam.com
3000M CNC
Motion Setup/Testing
Utility

Summary

Introduction to MST Utility

Accessing the MST Utility

How to navigate to and activate the Motion Setup/Testing Utility.

DC System Configuration and Testing

DSP² Board Balancing (F6)

Procedure to balance the DSP² board outputs for DC systems.

Servo Amplifier Output Balancing (F6)

Steps for balancing servo amplifier outputs in DC systems.

DC Amplifier Fault Diagnostics

AC System Configuration and Testing

DSP² Board Balancing for AC Systems

Procedure to balance the DSP² board outputs for AC systems.

AC Amplifier Output Balancing (F6)

Verifying settings and balancing outputs for AC servo amplifiers.

Setting AC Signal Gain (F7)

Procedure for setting the signal gain for AC servo amplifiers.

AC Amplifier Faults and Tests

System Tuning

Tuning (F8) Functionality

Utilizing the Tuning function for PID parameter optimization.

Saving and Exiting Tuning Results

Anilam 3000M Specifications

General

Axes	3
Control Type	CNC
Communication Interface	RS-232
Frequency	50/60 Hz
Input Voltage	120V AC