Anilam 6000M - Page 70

CNC Setup Utility Manual
P/N 70000490C - Machine Constants
2-60 All rights reserved. Subject to change without notice.
10-December-04
Table 2-2, Machine Constants Setup (Continued)
Machine Constant
Parameter
Function Settings
MC_4212:
X Home search feed
To set the speed at which the machine
travels the X-axis during Homing.
Range (1.0–12700.0)
10.0 (inches/minute) [Default]
MC_4213:
Y Home search feed
Sets the speed at which the machine
travels the Y-axis during Homing.
Range (1.0–12700.0)
10.0 (inches/minute) [Default]
MC_4214:
Z Home search feed
Sets the speed at which the machine
travels the Z-axis during Homing.
Range (1.0–12700.0)
10.0 (inches/minute) [Default]
MC_4215:
U Home search feed
Sets the speed at which the machine
travels the U-axis during Homing.
Range (1.0–12700.0)
10.0 (inches/minute) [Default]
MC_4217:
X Home preset
You can automatically preset Machine
Zero to any coordinates. When the
machine completes the homing
sequence, the CNC sets the display to
the preset values entered the X-axis.
Range (-25400.0000–25400.0000)
0.0000 [Default]
MC_4218:
Y Home preset
Sets home preset value for the Y-axis. Range (-25400.0000–25400.0000)
0.0000 [Default]
MC_4219:
Z Home preset
Sets home preset value for the Z-axis. Range (-25400.0000–25400.0000)
0.0000 [Default]
MC_4220:
U Home preset
Sets home preset value for the U-axis. Range (-25400.0000–25400.0000)
0.0000 (mm) [Default]
Miscellaneous Setup Parameters
MC_4301:
Max. programmed
linear axis feedrate
The maximum-programmed linear axis
feedrate sets a limit on how fast the
CNC allows the machine to travel a
linear axis in feedrate.
NOTE: You can override the
maximum-programmed feedrate with
the
FEEDRATE OVERRIDE switch. The
range of the switch is 0 to 120% of the
maximum-programmed feedrate. The
switch varies the feedrate in increments
of 10%.
Range (0.0–25400.0)
200.0 (inches/min) [Default]
MC_4302:
Linear axis dry run
feedrate
See “Linear and Rotary Axis Dry Run
Feedrate.”
Range (254.0–5080.0)
60.0 (inches/min) [Default]
(Continued…)