Page 18 of 24
Wash the filter in warm mild soapy water, rinse in clean fresh cold water and
let completely dry.
DO NOT scrub the filter or place in a dishwasher.
DO NOT use a hair dryer to dry the filter.
Refit the Filter (or replace with a new one) in the reverse method used for
disassembly.
The Centre component in which the filter is located, can also be removed for
cleaning.
To remove this part, grasp the edges where the tabs are located and pull
straight up and out.
IMPORTANT: When refitting the centre component back into the dust
canister, it must be fitted in the correct orientation.
To ensure this happens, there are two tabs on the edge of the centre
component which align with the two slots in the dust canister.
Ensure the Large Tab is aligned with the Large slot,
and the Small Tab is aligned with the Small Slot
Rotate the centre component until the tabs align
with the correct slots and then drop in.
NOTE: Incorrect fitment of this part will prevent
the vacuum cleaner from picking up the dust
and debris.
To Next Page
Loading...
