Command Directory 3-4 Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 3-33
ELI(xxxx)
Description: Sets list index to xxxx.
In list sweep mode, permits setting the list index for the current list.
Functional
Category: LIST SWEEP
Value: xxxx: 4-digit integer between 0000 and 1999
Example: LST; ELN3; ELI1263
Places the MG369xC in list sweep mode, selects list number 3, and sets the list index to
1263.
Related
Commands: LST, ELN(x)
Front Panel Key: Frequency | List | Edit List Index
ELN(x)
Description: Sets the list number to x.
In list sweep mode, permits selection of which of the four lists is to be accessed.
Functional
Category: LIST SWEEP
Value: x: 1-digit integer between 0 and 3
Front Panel Key: N/A
EP0
Description: Selects TTL-low to turn RF on during pulse modulation.
Permits selection of a TTL-low signal to turn the RF on during pulse modulation. If pulse
modulation is not installed, this command produces a syntax error.
Functional
Category: MODULATION
Related
Commands: EP1, P0, XP
Front Panel Key: Modulation | Pulse | L RF On
EP1
Description: Selects TTL-high to turn RF on during pulse modulation.
Permits selection of a TTL-high signal to turn the RF on during pulse modulation.
If pulse modulation is not installed, this command produces a syntax error.
Functional
Category: MODULATION
Related
Commands: EP0, P0, XP
Front Panel Key: Modulation | Pulse | H RF On
To Next Page
Loading...
Need help?
General
