3-4 Commands Command Directory
3-34 PN: 10370-10374 Rev. F MG369xC GPIB PM
ES0
Description: Inhibits end-of-sweep SRQ generation.
Inhibits an SRQ from being generated when Primary Status Byte one (End of Sweep) is
set. This is the default mode.
Functional
Category: STATUS
Related
Commands: SQ0, ES1
Front Panel Key: N/A
ES1
Description: Enables end-of-sweep SRQ generation.
Enables an SRQ to be generated when Primary Status Byte bit one (End of Sweep) is set
and SQ1 has been programmed. SQ1 enables the SRQ generation function.
Functional
Category: STATUS
Example: SQ1; ES1
Enables an SRQ on the end of a sweep.
Output Command: OSB (output primary status byte)
Related
Commands: SQ1, ES0
Front Panel Key: N/A
EXT
Description: Selects single sweep triggering.
Selects single sweep triggering for frequency, power level, or list sweeps. When single
sweep triggering is selected, a single sweep starts when a TRG or TRS command is
received. The RSS command resets the sweep to its start frequency, power level, or list
index whenever the command is received while a single sweep is in progress.
Functional
Category: SWEEP
Example: SSP; SF1; EXT; TRG
Turns on step sweep F1-F2, single trigger, and trigger one sweep.
Related
Commands: TRG, TRS, RSS
Front Panel Key: Frequency | Step Sweep | More > | Trigger > | Single
Frequency | List | Sweep > | Trigger > | Single
Level | Level Sweep | Trigger > | Single
To Next Page
Loading...
Need help?
General
