3-4 Commands Command Directory
3-54 PN: 10370-10374 Rev. F MG369xC GPIB PM
LDT <value> <unit>
Description: Opens the list sweep dwell time parameter.
Permits setting the dwell-time-per-step of the list sweep.
Functional
Category: LIST SWEEP
Value: 1 ms to 99 s
Units: MS, SEC
Example: LIB1234; LIE1237; EXT; LDT 10 MS; TRG
Implements a list sweep from current list index 1234 to index 1237 in single trigger mode
with a 10 ms dwell-time-per-step, then triggers a single sweep.
Related
Commands: LIB(xxxx), LIE(xxxx)
Front Panel Key: Frequency | List | Sweep > | Dwell Time
LE0
Description: Inhibits lock error SRQ generation.
Inhibits an SRQ from being generated when the Lock Error bit (Primary Status Byte
bit three) is set. This is the default mode.
Functional
Category: STATUS
Front Panel Key: N/A
LE1
Enables lock error SRQ generation.
Functional
Category: STATUS
LE1
Description: Enables lock error SRQ generation.
Enables an SRQ to be generated when Primary Status Byte bit three (Lock Error) is set
and SQ1 has been programmed.
Example: CSB; SQ1; LE1
Enable an SRQ on lock error.
Front Panel Key: N/A
To Next Page
Loading...
Need help?
General
