Anritsu MG369 C Series User Manual

3-4 Commands Command Directory
3-102 PN: 10370-10374 Rev. F MG369xC GPIB PM
SC1
Description: Turns off the SCAN modulation function.
If the SCAN Modulator was not installed, this command produces a syntax error.
Functional
Category: MODULATION
Front Panel Key: N/A
SD0
Description: Turns off the internal pulse stepped delay mode.
Functional
Category: MODULATION
Front Panel Key: Modulation | Pulse (internal, select one of the delay triggers) | Step Delay > | On/Off
SD1
Description: Turns on the internal pulse stepped delay mode.
Available with Delayed and Triggered With Delay trigger settings. Turns on the internal
pulse stepped delay mode if internal pulse modulation is on and the pulse trigger is set to
“delayed” or “trigger with delay. ”
Functional
Category: MODULATION
Front Panel Key: Modulation | Pulse (internal, select one of the delay triggers) | Step Delay > | On/Off
SDD <value> <unit>
Description: Opens the internal pulse stepped delay mode step size parameter.
Functional
Category: PARAMETER ENTRY
Value: 0 ms to 167 ms at 100 MHz pulse clock rate;
0 ms to 419 ms at 40 MHz pulse clock rate;
0 s to 1.6 s at 10 MHz pulse clock rate
Units: SEC, MS, US, NS
Output Command: ODD (in s)
Front Panel Key: Modulation | Pulse (internal, select one of the delay triggers) | Step Delay > | Step Size
SDE <value> <unit>
Description: Opens the internal pulse stepped delay mode delay 1 stop parameter.
Functional
Category: PARAMETER ENTRY
Value: 0 ms to 167 ms at 100 MHz pulse clock rate;
0 ms to 419 ms at 40 MHz pulse clock rate;
0 s to 1.6 s at 10 MHz pulse clock rate
Units: SEC, MS, US, NS
Output Command: ODE (in s)
Front Panel Key: Modulation | Pulse (internal, select one of the delay triggers) | Step Delay > | Stop
Delay

Anritsu MG369 C Series Specifications

General

Brand	Anritsu
Model	MG369 C Series
Category	Portable Generator
Language	English