Command Directory 3-4 Commands
MG369xC GPIB PM PN: 10370-10374 Rev. F 3-103
SDL <value> <unit>
Description: Opens the internal pulse stepped delay mode dwell-time-per-step parameter.
Functional
Category: PARAMETER ENTRY
Value: 100 microseconds to 10 s
Units: SEC, MS, US
Front Panel Key: Modulation | Pulse (internal, select one of the delay triggers) | Step Delay > | Step Time
Output Command: ODL (in s)
SDS <value> <unit>
Description: Opens the internal pulse stepped delay mode delay 1 start parameter.
Functional
Category: PARAMETER ENTRY
Value: 0 ms to 167 ms at 100 MHz pulse clock rate;
0 ms to 419 ms at 40 MHz pulse clock rate;
0 s to 1.6 s at 10 MHz pulse clock rate
Units: SEC, MS, US, NS
Front Panel Key: Modulation | Pulse (internal, select one of the delay triggers) | Step Delay > |
Start Delay
Output Command: ODS (in s)
SDT <value> <unit>
Description: Opens the step sweep dwell time parameter.
Functional
Category: PARAMETER ENTRY
Value: 1 ms to 99 s
Units: MS, SEC
Description: Permits setting the dwell-time-per-step value for the step sweep.
Related
Commands: LIS, LGS, SSP, SNS, SWT
Output Command: OSD returns the dwell time of the step sweep (in ms) to the controller.
Front Panel Key: Frequency | Step Sweep | Dwell Time
SE0
Description: Inhibits Syntax Error SRQ generation.
Inhibits an SRQ from being generated when the Syntax Error bit is set. This is the
default mode.
Functional
Category: STATUS
Front Panel Key: N/A