3-4 Commands Command Directory
3-104 PN: 10370-10374 Rev. F MG369xC GPIB PM
SE1
Description: Enables Syntax Error SRQ generation.
Enables an SRQ to be generated when primary status byte bit five (syntax error) is set
and SQ1 has been programmed.
Functional
Category: STATUS
Example: SQ1; SE1
Enables an SRQ on a syntax error.
Front Panel Key: N/A
SEC
Description: Seconds data terminator.
Functional
Category: DATA TERMINATOR
Front Panel Key: N/A
SF1
Description: Selects the F1-F2 sweep mode.
Selects a frequency sweep between F1 and F2.
Functional
Category: SWEEP
Related
Commands: F1, F2
Front Panel Key: Frequency | Step Sweep | Frequency Control > | F1-F2
Frequency | Manual Sweep | Frequency Control > | F1-F2
SF3
Description: Selects the F3-F4 sweep mode.
Selects a frequency sweep between F3 and F4.
Functional
Category: SWEEP
Related
Commands: F3, F4
Front Panel Key: Frequency | Step Sweep | Frequency Control > | F3-F4
Frequency | Manual Sweep | Frequency Control > | F3-F4
SL0
Description: Turns off the ALC power slope function.
Functional
Category: POWER LEVELING
Front Panel Key: Level | ALC Loop | Slope On/Off
To Next Page
Loading...
Need help?
General
