General GPIB Information 1-9 Ethernet LAN TCP/IP Requirements and Setup
MG369xC GPIB PM PN: 10370-10374 Rev. F 1-15
5. In the IP Address field, enter the IP address as indicated by your network administrator.
6. Enter the correct subnet mask and gateway for your network, if applicable.
7. Click the Update Flash button to complete the configuration.
The TCP/IP Confirmation Page appears as shown in Figure 1-6 on page 1-15 (refer to “TCP/IP General
Requirements and Settings” on page 1-13 for information on the below settings).
Figure 1-6. MG369xC Ethernet Device Configuration Page - Static TCP/IP Mode
To Next Page
Loading...
Need help?
General
