EasyManuals Logo

Anritsu MG369 C Series User Manual

Anritsu MG369 C Series
266 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #212 background imageLoading...
Page #212 background image
3-4 Commands Command Directory
3-112 PN: 10370-10374 Rev. F MG369xC GPIB PM
SNS <value> <unit>
Description: Opens the step sweep number of steps parameter.
Permits setting the number of steps for the step sweep.
Functional
Category: PARAMETER ENTRY
Value: 1 to 10,000
Units: SPS
Related
Commands: LIS, LGS, SDT, SSP, SWT
Output Command: OSS returns the number of steps of the step sweep to the controller.
Front Panel Key: Frequency | Step Sweep | More > | Number of Steps
SOF <value> <unit>
Description: Opens the frequency offset parameter of the Secondary unit.
Permits setting the frequency offset parameter for the Secondary unit. The frequency
setting is determined by the frequency range of the particular MG369xC model.
Functional
Category: PARAMETER ENTRY
Value: Frequency range of the MG369xC model
Units: GH, MH, KH, HZ
Front Panel Key: Frequency | CW | Primary Secondary > | Secondary Freqs. . . | VNA > | VNA Offset
SP0
Description: Deselects non-equally spaced step sweep.
Functional
Category: SWEEP
Related
Commands: SP1
Front Panel Key: N/A
Note
Use the SOF parameter entry command only to set the frequency offset for a Secondary unit that is
(1) Secondary to a Primary unit that is connected to a 360B VNA in a source or dual-source
configuration or (2) Secondary to a Primary unit that is programmed to perform non-sequential
frequency step sweeps.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Anritsu MG369 C Series and is the answer not in the manual?

Anritsu MG369 C Series Specifications

General IconGeneral
BrandAnritsu
ModelMG369 C Series
CategoryPortable Generator
LanguageEnglish

Related product manuals