AWARD BIOS
3-33
3.13 Load EEPROM Default
Except "Load Setup Default" and "Load Turbo Default", you may also use
"Save EEPROM Default " to save your own settings into EEPROM, and reload
by using this item.
3.14 Save EEPROM Default
You may use this item to save your own settings into EEPROM. Then, if the
data in CMOS is lost or you forget the previous settings, you may use "Load
EEPROM Default " to reload.
3.15 Exit without Saving
Use this function to exit Setup without saving the CMOS value changes. Do
not use this option if you want to save the new configuration.
3.16 NCR SCSI BIOS and Drivers
The NCR 53C810 SCSI BIOS resides in the same flash memory chip as the
system BIOS. The onboard NCR SCSI BIOS is used to support NCR 53C810
SCSI control card without BIOS code.
The NCR SCSI BIOS directly supports DOS, Windows 3.1 and OS/2. For
better system performance, you may use the drivers that come with the NCR
SCSI card or with your operating system. For details, refer to the installation
manual of your NCR 53C810 SCSI card.
To Next Page
Loading...
Need help?
General
