APC SMART-UPS 750 User Manual

3
Connect the Battery
The battery connector is located on the rear panel.
For battery connection, push the tethered jumper plug
into the corresponding port.
Connect Equipment and Power to the UPS
1. Connect equipment to the UPS.
Note: A laser printer draws significantly more power than other types of equipment and
may overload the UPS.
2. Add accessories to the Smart-Slot (optional).
3. Connect ground leads to the TVSS screw (optional). To make the connection, loosen the screw
and connect the surge suppression device ground lead. Tighten the screw to secure the lead.
4. Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension
cords.
The power cord is supplied in the UPS literature kit.
5. Turn on all connected equipment. To use the UPS as a master on/off switch, be sure all
connected equipment is on.
6. Press the
button on the front panel to power the UPS.
Note: The battery charges to 90% capacity during the first four hours of normal operation. Do
not expect full battery run capability during this initial charge period.
8. For optimal computer system security, install PowerChute Smart-UPS monitoring software.

APC SMART-UPS 750 Specifications

General

Output Power Capacity	500 Watts / 750 VA
Nominal Output Voltage	120V
Nominal Input Voltage	120V
Waveform Type	Sine wave
Output Connections	(6) NEMA 5-15R
Control panel	LED status display with On Line: On Battery: Replace Battery and Overload indicators
Form Factor	Tower
Battery Type	Lead-acid battery
Transfer Time	6 ms typical
Input Frequency	50/60 Hz
Output Frequency	50/60 Hz
Typical Recharge Time	3 hours
Interface Port(s)	USB
Output Voltage	120V
Communication Ports	USB