6-3. Mainboard
Applicable Model: iX Fit
Disassembly Steps:
1. Remove the 4 screws under the bottom and top cover can be separated < Refer to 6.1 >.
2. Pull up the mainboard upward and disconnect all the cables from the mainboard (Heating
Humidifier / Blower / DC cord).
Assembly Steps:
1. Connect the blower cable and make sure the loading direction is correct.
2. Connect the heating humidifier cable and DC jack cable.
3. While assembling the mainboard, make sure the 6 ribs should align to the 6 holes which on the
mainboard. Please note that one of the ribs is under the LCD display and pay attention not to lose
the 6 pieces of O-ring due to its light and small.
To Next Page
Loading...
