Assembly Notes: 4G/wireless+ SD Module
1. Make sure the direction of the front and back should be correct as picture below
The Service BOM also provides the whole components as F697C01-0000 for iX Auto and F697C03-0000 for iX
Sense <refer to Ch.9>.
6-5. Blower & Air path module
Applicable Model: iX Fit
Disassembly steps:
1. Remove the 4 screws under the bottom and then the device can be separated <Refer to 6.1>.
2. Pull up the mainboard and make it separated from device <Refer to 6.3>.
3. Remove the 6 O-rings.
4. Remove the 2 non-slip pads under the bottom cover.
To Next Page
Loading...
