Applicable Model : iX Sense
Disassembly Steps:
1. Remove the 4 screws under the bottom and top cover can be separated <Refer to 6.1>.
2. Remove the Wi-Fi FFC cable.
3. Pull up the mainboard upward and disconnect all the cables from the mainboard (Heating Humidifier
/ Blower / DC cord/Sensor tube).
Sense Assembly Steps:
1. Connect the blower, heated humidifier and DC jack cable into the mainboard.
2. While assembling the mainboard, make sure the 6 ribs should align to the 6 holes on the board.
Please note that one of the ribs is under the LCD display and pay attention not to lose the 6 pieces
of O-rings due to its light and small.
To Next Page
Loading...
